make bootable usb mac os sierra with windows 10

If both 32 bit and 64 bit versions are available, the 64 bit version is given in the table. The file names are current as of October 2, 2022. Use Microsoft Edge (or some other web browser) to download the following installers to your Downloads folder. This answer was also tested using a clean install of Windows 10 (version 21H2).īelow are the steps for making a bootable USB flash drive OS X Mavericks installer. Both hoxfixes can be downloaded from the Microsoft Update Catalog. This required downloading and installing hotfix KB3020369, followed by hotfix KB3125574. When testing using a clean install of Windows 7 SP1, Paragon Partition Manager Community Edition 64bit would not install unless the 'Convenience rollup update for 圆4 Windows 7 SP1' was first installed. Since El Capitan has the same system requirements as Mavericks, you may instead wish to install El Capitan.

You can make a bootable USB flash drive OS X Mavericks installer from your Windows 7 installation. So basically, the USB drive cannot have any high level formatting, the Windows system should detect the drive as 'not formatted' for this to work, which it will if prepped right with Diskpart. When I tried to inject the image, Transmac told me that the drive was 'write protected'. Note: I use 'Rufus' for all other USB writing and formatting for Windows systems, it's a great app, but I had previously tried to format the drive as GPT using that, as a Fat32 partition. DISKPART> convert gptĭiskPart successfully converted the selected disk to GPT format. DISKPART> cleanĭiskPart succeeded in cleaning the disk.

(Find the disk number) DISKPART> select disk x (from result of List Disk)ĭisk x is now the selected disk. Here are the Diskpart commands used to prep the Flash Drive, just to have them here in case my Link does not work: diskpart I've been trying to post this to confirm that it works for some time, I just hope it helps someone else, because it is a very easy solution.

Someone had reported that the method for using DISKPART did not work, but I have done this twice and it works remarkably well, and it's the only method I could find to create a Mac-Bootable Flash. I used TransMac on Windows 7 to restore the image file I had to the Flash Drive, it created a bootable Mac image on my flash drive. Dryden's Link, I was able to use the Diskpart command to clean and prep a GPT partition on a flash drive for an OSX Mavericks install image. I was never able to write a Mac installer image to my Flash Drive and have it bootable, unless I did it on a Mac.

I know this question is old but it is still valid.

Make bootable usb mac os sierra with windows 10